Skip to content

What is the bolt pattern for a 2004 Acura MDX?

This Factory OEM Acura rim comes equipped on a 2004-2006 Acura MDX. This is an aluminum wheel with a diameter of 17″ and a width of 6.5″. This Acura MDX wheel has 5 lug holes and a bolt pattern of 115mm.


What size are Acura lug nuts?

Dorman – Autograde – Wheel Nut M12-1.50 Acorn – 19mm Hex, 29.5mm Length (sold by each) (Part No. 611-201)


Are all wheel lug nuts the same size?

The three most common hex sizes for lug nuts are 17 mm, 19 mm, and 21 mm, while 22 mm, 23 mm, 11⁄16 inch (17.5 mm), and 13⁄16 inch (20.6 mm) are less commonly used.


Can you machine wheels to change Offset?

Yes it’s possible. If you want to increase the number of positive offset (ex. from +30 to +35), the back of each alloy wheel has to be machined down evenly using a special CNC machine. Note that not all offset changes can be achieved.


Can you drive with a missing lug nut?

If you are missing a lug nut, it is important to have it replaced as soon as possible. It is potentially dangerous to drive around with a missing lug nut because of the extra pressure exerted on the wheel. This pressure can damage the wheel bearings, studs, and cause other lug nuts to fall off.


How do I know what lug nuts I need?


Where is Acura MDX spare tire?

The Acura MDX has a compact spare tire stored underneath the vehicle. To access it, you’ll need to open the trunk.

Also read:  How do you change the passenger side of a wing mirror?


How do you measure bolt pattern on a tire?


What is a 5×5 lug pattern?

The 5×5 Bolt Pattern or Pitch Circle Diameter (PCD) is made up of the stud count (5) and the bolt circle measurement (5), the notional circle determined by the center position of the studs. The 5×5 bolt pattern is common to Buick, Cadillac, Chevrolet, Chrysler, Daewoo, Dodge and Fiat vehicles.


What vehicle has 5 on 5 bolt pattern?

This was the bolt pattern used for Cadillac and other luxurious vehicles from the 1950’s. This includes classic Buick, Oldsmobile and Pontiac. So if you’re using a big Olds rear end, you likely have a 5×5 bolt pattern.