Skip to content

Where is oil filter on 2008 Acura TL?


How many quarts does an Acura TL 2008 take?

Engine Oil 12/1/11) indicates that 0W-20 is acceptable to use in this application. Capacity: Without filter 4.2 quartsAfter refill check oil level. With filter 4.5 quartsAfter refill check oil level.


How much oil does a 3.2 L Acura TL take?

With filter 4.6 quartsAfter refill check oil level. Without filter 4.2 quartsAfter refill check oil level.


How many quarts of oil does a Acura TL take?

Engine Oil 12/1/11) indicates that 0W-20 is acceptable to use in this application. Capacity: Without filter 4.2 quartsAfter refill check oil level. With filter 4.5 quartsAfter refill check oil level.


How do you reset the maintenance required light on a 2008 Acura TL?


How many quarts of oil for a 2009 Acura TL SH AWD?

Protect your vehicle with the world’s best synthetic oil for your Tl. With filter 4.5 quarts After refill check oil level. Without filter 4.2 quarts After refill check oil level. Get the best synthetic oil for your Tl.


How do you reset the oil light on a 2009 Acura TL?

To reset the oil in a 2009 acura tl you need to put the car in the on position with the engine off, press select/reset until oil life is displayed, the hold down select/reset for 10 seconds.


Can 5w30 be used instead of 5w20?

In general, it is not recommended that you use 5w30 oil (or any other oil weight) in place of 5w20 oil, as the slightest difference in viscosity can potentially damage your engine.

Also read:  Whats the difference between 2020 and 2021 RDX?


What is the difference between 0W-20 and 5W-20?

As 0W20 is a far thinner oil than 5W-20, it is more stable at cold temperature than the latter and flows smoothly through the critical engine parts. 5W-20 is a comparatively thicker viscosity oil and is better for a normal operating temperature range of -22°F to 68°F.


How do I turn off the service light on my Acura TL?

Press and hold the SELECT and RESET buttons on the instrument panel. Turn the ignition to position (II) do not start engine. Hold the SELECT and RESET buttons until the indicator resets, 10 seconds. Turn ignition off and then start the engine to verify the indicator has been reset.