Skip to content

Why does my car say battery saver active?

The Battery Saver Active message can appear on your driver information center (DIC). When the DIC displays this alert, that means that your battery has a low charge, and your vehicle is shutting off certain systems that may drain the battery of life.


Where is the fuse box on a Chevy Traverse?

Fuse box location It is located underneath the instrument panel, on the passenger side, under the cover.


What kills a car alternator?

Running in full charge mode continuously can kill an alternator, so trying to have your new alternator try and charge your dead battery can result in immediate alternator failure.


Will check engine light come on for bad alternator?

A faulty alternator not only turns the check engine light on, it also risks your safety. If the alternator fails when you’re driving, the car radio will go off, the interior lights will dim, and you will experience extreme difficulty in driving. The reason being all power is lost.


Can you drive with battery saver active?

While not completely dangerous, the Battery Saver Active message should not be ignored. You might drive your car, but depending on what causes this warning message to pop up, you might get stranded. I always recommend not driving the vehicle if any of the warning lights are on.


How do you service battery charging system?


What is PDM fuse?

Power Distribution Modules (PDM) for vehicles or commercial equipment feature multiple electrical power outputs, acceptance of many fuses, fuse types & relays and allow for custom configuration.

Also read:  How much is a water pump for a Acura TL?


Where is the starter relay on a Chevy Traverse?

The starter relay is used to send very high amperage to the starter motor while operating the starter motor with a low amperage circuit. This relay is normally located under the hood, inside the power distribution center or fuse block.


What is BCM fuse?

The Body Control Module is a generic term for an electronic control unit, responsible for monitoring and controlling various electronic accessories in a vehicle’s body. Typically, in a car, the BCM controls the power windows, power mirrors, air conditioning, immobilizer system, central locking, etc.


Will a failing alternator throw a code?

HOW TO DIAGNOSE A FAILING ALTERNATOR. If you have a “Check Engine” light on, connect a code reader to the diagnostic port. If you find code P0562, you very likely have a failing alternator (note that codes may vary by vehicle make/model/year). Get it checked out before it fails entirely.